NAVIGATION SYSTEM (for DVD) > Microphone Circuit between Microphone and Navigation Receiver Assembly |

| 1.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the K7 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K7-20 (MIC-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K7-17 (MACC) - Body ground | Ignition switch ACC | 4.75 to 5.25 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - ROOF CONSOLE BOX) |
![]() |
Disconnect the K7 navigation receiver assembly connector.
Disconnect the W7 roof console box assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K7-17 (MACC) - W7-10 (ACC) | Always | Below 1 Ω |
| K7-19 (MIC+) - W7-9 (MIC+) | Always | Below 1 Ω |
| K7-20 (MIC-) - W7-8 (MIC-) | Always | Below 1 Ω |
| K7-5 (SNS2) - W7-14 (SGND) | Always | Below 1 Ω |
| K7-17 (MACC) - Body ground | Always | 10 kΩ or higher |
| K7-19 (MIC+) - Body ground | Always | 10 kΩ or higher |
| K7-20 (MIC-) - Body ground | Always | 10 kΩ or higher |
| K7-5 (SNS2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER CHECK |
Replace the telephone microphone assembly with a normal one (Click here).
Check if the same problem occurs again.
| Result | Proceed to |
| OK | A |
| NG (for Double Cab) | B |
| NG (CrewMax) | C |
|
| ||||
|
| ||||
| A | ||
| ||