Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Vehicle Speed Signal Circuit

for Preparation Click here


DESCRIPTION

This circuit sends a speed signal from the combination meter to the navigation receiver assembly.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, both systems in the diagram below will not operate normally.


WIRING DIAGRAM


E231665E01


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL


    E235191E03
  1. Enter the "Vehicle Signal Check Mode" screen (Click here).

  1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the display are the same.

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual vehicle speed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the K6 navigation receiver assembly connector.

  1. Disconnect the J28 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-3 (SPD) - J28-35 (+S)
    Always
    Below 1 Ω
    K6-3 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    E190309E15
  1. Remove the combination meter assembly with the connectors still connected.

  1. Connect an oscilloscope to terminal J28-35 (+S) and body ground.

  1. Turn the ignition switch to ON.

  1. Check the signal waveform according to the condition(s) in the table below.
    Measurement Condition 
    Item
    Condition
    Terminal No. (Symbol)
    J28-35 (+S) - Body ground
    Tool Setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Vehicle being driven at approximately 20 km/h (12 mph)

    OK:
    The waveform displayed is as shown in the illustration.

    HINT:
    When the system is functioning normally, one wheel revolution generates 4 pulses.
    As the vehicle speed increases, the width indicated by "A" in the illustration narrows.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)
    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)