SEAT BELT WARNING SYSTEM > Front Passenger Side Seat Belt Warning Light Malfunction |

| 1.CHECK FOR DTC |
Check for DTCs.
for CAN communication system (Click here).
for Airbag system (Click here).
for Occupant classification system (Click here).
| Result | Proceed to |
| DTC is not output | A |
| CAN communication system DTC is output | B |
| Airbag system DTC is output | C |
| Occupant classification system DTC is output | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (ECU-IG No. 1) |
Remove the ECU-IG No. 1 fuse from the passenger side junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (FRONT PASSENGER SEAT BELT WARNING LIGHT) |
Operate the Techstream according to the steps on the display and select "Active Test".
| Item | Test Part | Control Range | Diagnostic Note |
| Front Passenger Side Seat Belt | Front passenger side seat belt warning light | ON or OFF | - |
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - COMBINATION METER AND BATTERY) |
![]() |
Disconnect the J37 panel connector.
Disconnect the J28 meter connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J37-14 (PBEW) - J28-15 (P/SB) | Always | Below 1 Ω |
| J37-14 (PBEW) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| J37-16 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 5.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
for Column Shift Type:
Remove the integration control and panel (Click here).
for Floor Shift Type:
Remove the integration control and panel (Click here).
Connect the positive (+) battery lead to terminal 16 (IG+), and the negative (-) battery lead to terminal 14 (PBEW).
Check that the front passenger side seat belt warning light comes on.
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 6.REPLACE FRONT SEAT INNER BELT ASSEMBLY RH |
Temporarily replace the front seat inner belt RH with a new or normally functioning one (Click here).
| NEXT | |
| 7.CHECK FRONT PASSENGER SIDE SEAT BELT WARNING LIGHT |
Check the front passenger side seat belt warning light function (Click here).
|
| ||||
| OK | ||
| ||