The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the Techstream.
Perform troubleshooting in accordance with the table below.
| Result | Proceed to |
|---|---|
| MIL remains ON | A |
| MIL does not illuminate | B |
A
B
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if any DTCs have been stored. Note down any DTCs.
Clear DTCs (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Check if the MIL goes off.
MIL goes off
OK
NG
Disconnect the A24 ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
MIL is not illuminated.
OK
NG
Disconnect the A24 ECM connector.
Disconnect the J28 combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-24 (W) or J28-10 (CHK) - Body ground | Always | 10 kΩ or higher |
OK
NG
Check if the MIL is illuminated when the ignition switch is turned to ON.
MIL should be illuminated.
OK
NG
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed to |
|---|---|
| Engine starts | A |
| Engine does not start* | B |
*: The Techstream cannot communicate with the ECM.
A
B
Disconnect the A24 ECM connector.
Disconnect the J28 combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-24 (W) - J28-10 (CHK) | Always | Below 1 Ω |
OK
NG