Home › Engine / Hybrid System › 3UR-FBE FUEL › FUEL PUMP › 2015.08–2016.08
RM27M0U _51 Engine / Hybrid System _049096 3UR-FBE FUEL _0233951 FUEL PUMP A

3UR-FBE FUEL  FUEL PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the fuel injector (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).


PROCEDURE

Hide 23280 2.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

Hide 77020A 3.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

a.

Apply a light coat of gasoline to a new gasket and install it to the fuel tank.


b.
A194658E02
2.354,0.531 2.417,0.156 2.417,0.156 2.531,0.156 false 2.354,1.479 2.76,1.479 false 2.802,1.385 3.323,1.573 0.521,0.188 10 true Groove 2.563,0.083 3.26,0.313 0.698,0.229 10 true Protrusion

Align the protrusion of the fuel suction with pump and gauge tube assembly with the groove of the fuel tank.


c.

Install the fuel suction with pump and gauge tube assembly into the fuel tank.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge.



d.

Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube assembly, tighten the retainer one complete turn by hand.


e.
A259584E06
2.813,0.219 2.656,0.219 2.656,0.219 2.417,0.479 true 2.844,0.135 3.167,0.344 0.323,0.208 10 true SST

Set SST on the retainer.

SST
09808-14030  

HINT:
·

Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket is not moved out of position.

·

Securely attach the claws of SST to the protrusions of the retainer and fix SST in place.

·

Install SST while pressing the claws of SST against the retainer (toward the center of SST).




f.
A259587E04
1.156,3.333 1.76,3.667 1.76,3.667 2.208,3.125 false 1.573,1.74 1.729,1.74 1.729,1.74 1.927,3.031 true 2.771,0.229 2.656,0.229 2.656,0.229 2.375,0.469 false 2.823,0.146 3.271,0.51 0.448,0.365 10 true SST 1.073,3.708 2.385,3.896 1.313,0.188 10 true Fuel Tank Side Mark 1.802,4.052 1.948,4.24 0.146,0.188 10 false A 0.375,1.656 1.635,1.885 1.26,0.229 10 true Retainer Side Mark

Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.

SST
09808-14030  

HINT:

Fit the tips of SST onto the ribs of the retainer.



Hide 4.INSTALL FUEL PRESSURE SWITCHING VALVE ASSEMBLY

Hide 77100 5.INSTALL FUEL TANK ASSEMBLY

a.