1. DISCHARGE FUEL SYSTEM PRESSURE
25620
2.REMOVE EGR VALVE ASSEMBLY
3.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
55701J
4.REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
Disconnect the washer hose and detach the 2 wire harness clamps.
Remove the 7 bolts and cowl top outer panel sub-assembly.
12263
5.REMOVE VENTILATION HOSE ASSEMBLY
Slide the 2 clamps and disconnect the ventilation hose assembly from the ventilation pipe of the cylinder head cover sub-assembly LH and cylinder head cover sub-assembly RH.
Remove the bolt and ventilation hose assembly.
6.REMOVE AIR TUBE SUB-ASSEMBLY LH
17111
7.REMOVE INTAKE MANIFOLD
Disconnect the throttle body connector from the throttle body assembly.
Slide the clamp and disconnect the No. 4 water by-pass hose from the front water by-pass joint.
Slide the clamp and disconnect the ventilation hose from the intake manifold.
Disconnect the 2 vacuum switching valve connectors.
Slide the clamp and disconnect the purge line hose from the purge VSV.
Slide the clamp and disconnect the vacuum hose from the union to connector tube hose assembly.
Remove the bolt.
Detach the 3 engine wire harness clamps from the 3 wire harness brackets.
Detach the 4 clamps from the fuel tube sub-assembly.
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly RH (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly LH (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Remove the 2 nuts, 8 bolts, intake manifold and 2 gaskets.
23901
8.REMOVE FUEL TUBE SUB-ASSEMBLY
Remove the bolt and fuel tube sub-assembly from the intake manifold.
11254
9.REMOVE V-BANK COVER BRACKET
Remove the 2 bolts and V-bank cover bracket.
11254B
10.REMOVE V-BANK COVER BOLT
Remove the V-bank cover bolt from the intake manifold.
11.REMOVE STUD BOLT
Using an E5 "TORX" socket wrench, remove the 2 stud bolts.
25860
12.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
Disconnect the 2 vacuum hoses from the vacuum switching valve assembly.
Remove the bolt and vacuum switching valve assembly.
23829A
13.REMOVE PURGE VSV
Slide the clamp and disconnect the purge line hose from the intake manifold.
Remove the bolt and purge VSV.
44774
14.REMOVE UNION TO CONNECTOR TUBE HOSE ASSEMBLY
Slide the clamp and disconnect the union to connector tube hose from the intake manifold.
Remove the 2 bolts and union to connector tube hose assembly.
Remove the 2 bolts and 2 wire harness brackets.
89421B
15.REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR
22030
16.REMOVE THROTTLE BODY ASSEMBLY
Remove the 4 bolts, throttle body assembly and gasket.