16100
1.INSTALL WATER PUMP ASSEMBLY
Install a new gasket and the water pump with the 8 bolts shown in the illustration.
16173
2.INSTALL WATER PUMP PULLEY
Temporarily install the pulley with the 4 bolts.
Using SST, hold the pulley and tighten the 4 bolts.
16323
3.INSTALL WATER INLET HOUSING
Install a new gasket to the water pump.
Install the No. 3 water by-pass hose and water inlet housing with the 3 bolts.
Install the hose so that the direction of the hose clamp is as indicated in the illustration.
Install the air tube bracket bolt.
Connect the No. 5 water by-pass hose.
Install the hose so that the direction of the hose clamp is as indicated in the illustration.
Connect the air pump connector clamp's holder.
Attach the wire harness clamp.
Connect the air pump connector.
Connect the No. 2 and No. 3 air hoses.
16268L
4.CONNECT WATER BY-PASS PIPE (w/ Oil Cooler)
Connect the water by-pass pipe with water hose.
Install the hose so that the direction of the hose clamp is as indicated in the illustration.
Install the 3 bolts.
Connect the No. 6 water by-pass hose.
16261G
5.INSTALL NO. 1 WATER BY-PASS HOSE
16711
6.INSTALL FAN SHROUD
16571
7.CONNECT INLET RADIATOR HOSE
16572
8.CONNECT OUTLET RADIATOR HOSE
17700
9.INSTALL AIR CLEANER ASSEMBLY
17880
10.INSTALL AIR CLEANER HOSE ASSEMBLY
11.ADD ENGINE COOLANT
12.INSPECT FOR COOLANT LEAK
11209
13.INSTALL V-BANK COVER SUB-ASSEMBLY
51441
14.INSTALL NO. 1 ENGINE UNDER COVER