Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234088 TIRE PRESSURE WARNING SYSTEM C

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  C2165/65  Abnormal Temperature Inside ID1 Tire  C2166/66  Abnormal Temperature Inside ID2 Tire  C2167/67  Abnormal Temperature Inside ID3 Tire  C2168/68  Abnormal Temperature Inside ID4 Tire  


DESCRIPTION

Each tire pressure warning valve and transmitter measures the internal temperature of its tire as well as the tire pressure, and transmits the information to the tire pressure warning ECU along with the transmitter ID. If the measured temperature is out of the specified range, the tire pressure warning ECU recognizes it as a malfunction, outputs DTCs, and the tire pressure warning light blinks for 1 minute and then remains on.

DTC Code DTC Detection Condition Trouble Area
C2165/65
C2166/66
C2167/67
C2168/68
Temperature inside the tire exceeds 119°C (246.2°F) more than a specified times.
·

Tires

·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU



HINT:

It is necessary to perform the procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and note them down before removal.

·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.



PROCEDURE

1.CHECK TIRES
a.

Check that the tires are not flat, and have no indication of tire pressure drop.

OK:

Tires are normal.


HINT:

If a tire is damaged, the tire pressure warning valve and transmitter may also have been damaged at the same time.




OK

2.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

NG

REPLACE TIRE AND TIRE PRESSURE WARNING VALVE AND TRANSMITTER

2.IDENTIFY TRANSMITTER CORRESPONDING TO DTC

NEXT

3.REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
3.REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
a.

Replace the identified tire pressure warning valve and transmitter with a new one (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING VALVE AND TRANSMITTER>REMOVAL).

HINT:
·

Before installing a new tire pressure warning valve and transmitter, read and write down its transmitter ID.

·

The transmitter IDs for the tire pressure warning valve and transmitters that are not replaced should be checked using the Techstream and recorded.





NEXT

4.REGISTRATION OF TRANSMITTER ID
4.REGISTRATION OF TRANSMITTER ID
a.

Register the transmitter ID for all 4 tires (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION).



NEXT

5.PERFORM INITIALIZATION
5.PERFORM INITIALIZATION

NEXT

6.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
6.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)

A

REPLACE TIRE PRESSURE WARNING ECU

B

END