Home › Engine / Hybrid System › DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY(for 1UR-FE)
RM27M0U _51 Engine / Hybrid System _049121 DIFFERENTIAL _0234098 DIFFERENTIAL CARRIER ASSEMBLY(for 1UR-FE) A

DIFFERENTIAL  DIFFERENTIAL CARRIER ASSEMBLY(for 1UR-FE)  INSTALLATION  


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.
C159767

Clean the contact surfaces of the rear differential carrier and the rear axle housing.


b.

Install a new gasket and the differential carrier with the 10 washers and 10 nuts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)

NOTICE:

Be careful not to damage the installation surface.



Hide 42312 2.INSTALL REAR AXLE SHAFT LH

a.

Install the rear axle shaft LH (See page Drivetrain>AXLE>REAR AXLE SHAFT>INSTALLATION).


Hide 42311L 3.INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.


Hide 37110 4.INSTALL PROPELLER SHAFT ASSEMBLY

a.

Install the propeller shaft for 2WD (See page Drivetrain>PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY(for 2WD)>INSTALLATION).


b.

Install the propeller shaft for 4WD (See page Drivetrain>PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY(for 4WD)>INSTALLATION).


Hide 6.INSTALL REAR WHEEL

a.

Install the rear wheels.

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)