Home › Engine / Hybrid System › DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY(for 3UR-FE, 3UR-FBE)
RM27M0U _51 Engine / Hybrid System _049121 DIFFERENTIAL _0234103 DIFFERENTIAL CARRIER ASSEMBLY(for 3UR-FE, 3UR-FBE) A

DIFFERENTIAL  DIFFERENTIAL CARRIER ASSEMBLY(for 3UR-FE, 3UR-FBE)  INSTALLATION  


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.
C159767

Clean the contact surfaces of the rear differential carrier and rear axle housing.


b.

Install a new gasket and the differential carrier with the 10 washers and 10 nuts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)

NOTICE:

Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.



Hide 42312 2.INSTALL REAR AXLE SHAFT LH

a.

Install the rear axle shaft LH (See page Drivetrain>AXLE>REAR AXLE SHAFT>INSTALLATION).


Hide 42311L 3.INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.


Hide 37110 4.INSTALL PROPELLER SHAFT ASSEMBLY

a.

Install the propeller shaft for 2WD (See page Drivetrain>PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY(for 2WD)>INSTALLATION).


b.

Install the propeller shaft for 4WD (See page Drivetrain>PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY(for 4WD)>INSTALLATION).


Hide 6.INSTALL REAR WHEEL

a.

Install the rear wheels.

Torque:
for aluminum wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for steel wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)