Home › Drivetrain › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234104 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

WF1AM TRANSFER  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  P17A2  Automatic Disconnecting Differential Motor Control Circuit High  


DESCRIPTION

This DTC is detected when a short to B+ is detected in the A.D.D. shift motor drive circuit.

DTC Code DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P17A2
1.

Ignition switch ON (when not switching between 2WD and 4H)

2.

Short to B+ in the A.D.D. shift motor drive circui

3.

1 second or more

4.

1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

A.D.D. actuator (differential vacuum actuator assembly)



WIRING DIAGRAM

PROCEDURE

1.CHECK DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)
U151874E02
1.146,1.542 0.594,2.427 false 1.49,1.552 1.938,2.479 false 1.667,0.563 1.979,0.719 0.313,0.156 10 false A25 0.396,2.448 0.74,2.677 0.344,0.229 10 false DM1 1.844,2.49 2.188,2.719 0.344,0.229 10 false DM2 0.188,0.104 0.521,0.333 0.333,0.229 10 false *a

a.

Disconnect the 4 wheel drive control ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A25-1 (DM1) or A25-2 (DM2) - Body ground Ignition switch ON Below 1 V


Text in Illustration
*a Front view of wire harness connector
(to 4 Wheel Drive Control ECU)



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY - BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY - BODY GROUND)
a.

Disconnect the A25 4 wheel drive control ECU connector.


b.

Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A25-1 (DM1) or G1-1 (DM1) - Body ground Ignition switch ON Below 1 V
A25-2 (DM2) or G1-2 (DM2) - Body ground Ignition switch ON Below 1 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR