Home › Brake › BRAKE › BRAKE PEDAL
RM27M0U _54 Brake _049123 BRAKE _0234115 BRAKE PEDAL A

BRAKE  BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad onto the brake pedal.


Hide 55106 2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C154462

Install the brake pedal support with the 4 nuts.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)


b.

Install the No. 3 brake pedal bracket to the brake pedal support.


c.
C208543

Temporarily install the brake pedal support, No. 3 brake pedal bracket and brake pedal lever with the bolt and nut.


d.
C208544E02
2.063,1.573 2.417,1.573 false 2.448,1.49 3.344,1.938 0.896,0.448 10 true Brake Pedal Bracket

Install the bolt to the No. 3 brake pedal bracket.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


e.

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal and return spring mounting bracket of the No. 3 brake pedal bracket.


f.

Install the brake pedal return spring.


g.

Tighten the bolt and nut.

Torque:
23 N*m (239 kgf*cm, 17 ft.*lbf)


Hide 47264A 3.INSTALL PUSH ROD PIN

a.

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.


b.

Set the push rod clevis in place, insert the push rod pin from outside the vehicle and then install a new clip.

NOTICE:

After assembly, check that the pedal operates smoothly.



Hide 84340 4.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Install the stop light switch mounting adjuster (See page Vehicle Interior>LIGHTING>STOP LIGHT SWITCH>INSTALLATION).


Hide 84340 5.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.

Attach the harness clip.


b.

Install the stop light switch (See page Vehicle Interior>LIGHTING>STOP LIGHT SWITCH>INSTALLATION).


c.

Connect the stop light switch connector.


Hide 87201 6.INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY

a.
C154523

Install the air duct with the bolt.


Hide 73900 7.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Install the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>DRIVER SIDE KNEE AIRBAG ASSEMBLY>INSTALLATION).


Hide 47101 8.CHECK AND ADJUST BRAKE PEDAL

a.

Check and adjust brake pedal (See page Brake>BRAKE>BRAKE PEDAL>ADJUSTMENT).


Hide 28800 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 47201 10.CHECK MASTER CYLINDER PRESSURE SENSOR SIGNAL