Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)
RM27M0U _55 Steering _049129 STEERING COLUMN _0234197 STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 45187 4.REMOVE LOWER NO. 3 STEERING WHEEL COVER

Hide 45186 5.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45100 7.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel set nut.


b.
C290066E03
2.698,0.354 2.49,0.229 2.49,0.229 2.271,0.229 false 2.385,0.229 2.677,0.438 false 1.094,1.156 0.531,0.333 0.531,0.333 0.375,0.333 true 2.104,0.177 2.458,0.438 0.354,0.26 10 false *a 0.365,1.854 0.625,2.094 0.26,0.24 10 false *b 2.406,1.625 2.76,1.885 0.354,0.26 10 false *c 0.052,0.271 0.385,0.531 0.333,0.26 10 true SST

Put matchmarks on the steering wheel and main shaft.

Text in Illustration
*a Matchmark
*b Hold
*c Turn


c.

Using SST, remove the steering wheel.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05011)


Hide 45287 8.REMOVE LOWER STEERING COLUMN COVER

a.
C290108

Remove the 2 screws.


b.

Detach the 2 claws to remove the lower steering column cover.


Hide 45286B 9.REMOVE UPPER STEERING COLUMN COVER

a.
C290109

Detach the 4 clips.


b.

Detach the claw to remove the upper steering column cover.


Hide 10.REMOVE TILT AND TELESCOPIC MANUAL SWITCH

a.
C159804

Disconnect the connector.


b.

Using a screwdriver, detach the claw and pull out the tilt and telescopic switch.

NOTICE:

Pushing on the claw too hard will break the claw.


HINT:

Tape the screwdriver tip before use.



Hide 84306 11.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.
C154522

Disconnect the 5 connectors from the combination switch with spiral cable.


b.
C290110

Using pliers, grip the claws of the clamp and remove the combination switch with spiral cable from the steering column.


Hide 67914 12.REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)

Hide 67914 13.REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)

Hide 55046A 16.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 17.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 87201 18.REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY

a.
C154523

Remove the bolt and air duct.


Hide 45220 19.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C155149

Remove the 3 bolts and nut.


b.
C154524E03
1.229,0.938 0.969,1.708 false 1.073,1.01 0.969,1.688 false 0.896,1.74 1.271,1.948 0.375,0.208 10 false *a

Put matchmarks on the steering intermediate shaft and the steering column.

Text in Illustration
*a Matchmark


c.

Remove the bolt and steering intermediate shaft from the steering column.


d.
C155150E03
1.385,1.385 0.635,1.823 false 0.646,1.813 1.719,1.542 false 0.448,1.823 1.448,2.146 1,0.323 10 true *a

Put matchmarks on the No. 2 steering intermediate shaft and steering intermediate shaft.

Text in Illustration
*a Matchmark


e.

Remove the bolt and steering intermediate shaft from the No. 2 steering intermediate shaft.


Hide 45203 20.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.
C155151E03
0.646,1.615 1.646,1.313 false 0.646,1.615 1.677,1.542 false 0.427,1.51 0.635,1.719 0.208,0.208 10 false *a

Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.

Text in Illustration
*a Matchmark


b.

Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.


Hide 45250 21.REMOVE STEERING COLUMN ASSEMBLY

a.
C290097

Remove the bolt and 2 nuts. Then remove the steering column from the instrument panel reinforcement.