Home › Steering › POWER STEERING › VANE PUMP(for 1UR-FE)
RM27M0U _55 Steering _049130 POWER STEERING _0234202 VANE PUMP(for 1UR-FE) A

POWER STEERING  VANE PUMP(for 1UR-FE)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

HINT:

Before performing the following procedures, move the spacer until the vane pump can be installed.


A163333E08
1.75,1.844 1.688,1.844 false 1.823,1.854 0.885,1.656 false 1.813,1.771 1.99,1.948 0.177,0.177 10 true *a

Text in Illustration
*a Spacer

a.
C161012

Install the vane pump assembly with the 2 bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 44410 2.INSTALL PRESSURE FEED TUBE

a.

Install a new gasket to the pressure feed tube.


b.
C161011E02
2.842,0.45 3.171,0.648 0.329,0.197 10 *1 2.134,1.476 2.604,0.519 2.604,0.519 2.776,0.519 false

Install the pressure feed tube with the union bolt.

Torque:
51 N*m (520 kgf*cm, 38 ft.*lbf)

Text in Illustration
*1 Pressure Feed Tube


Hide 3.CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

a.
C161010

Connect the power steering oil pressure sensor connector.


Hide 44348A 4.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C161009E02
3.008,0.79 3.326,1.014 0.317,0.224 10 *1 2.424,1.387 2.812,0.861 2.812,0.861 2.988,0.861 false

Connect the No. 1 oil reservoir to pump hose, and slide the clamp to secure it.

Text in Illustration
*1 Pump Hose


Hide 5.CONNECT WIRE HARNESS CLAMP

a.
C161008

Connect the wire harness clamp.


Hide 9.ADD POWER STEERING FLUID

Hide 11.INSPECT FOR POWER STEERING FLUID LEAK

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

Some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).