Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234208 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

HINT:
·

Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Double Cab) (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL).

·

Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Regular Cab) (see page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL).



Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Regular Cab)

a.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Remove the 6 bolts and curtain shield airbag.

B166466


Hide 62180A 5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Double Cab)

a.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Remove the 8 bolts and curtain shield airbag.

B166467