Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234210 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.


HINT:

Use the same procedures for the LH side and RH side.


PROCEDURE

Hide 73920A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

CAUTION:
·

The nuts must not be reused.

·

Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.



a.
B360678

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Connect the 2 clamps.


Hide 71552S 2.INSTALL SEPARATE TYPE FRONT SEATBACK PAD

Hide 87510N 3.INSTALL FRONT SEAT BACK HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 71074S 4.INSTALL SEPARATE TYPE FRONT SEATBACK COVER

Hide 5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71868A 6.INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD LH

Hide 71812D 7.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).