Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234210 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

If the side airbag was deployed, replace the front seat airbag assembly LH, front seat back cover and front seat frame with adjuster assembly with the necessary parts in accordance with the extent of the collision damage.

·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.



HINT:

Use the same procedures for the LH side and RH side.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 71868A 5.REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH

Hide 6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71074S 7.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Hide 87510N 8.REMOVE FRONT SEAT BACK HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 71552S 9.REMOVE SEPARATE TYPE FRONT SEATBACK PAD

Hide 73920A 10.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

a.
B355990

Detach the 2 clamps from the front seatback main frame sub-assembly.


b.

Remove the 2 nuts and front seat airbag assembly LH.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seat back main frame sub-assembly is not deformed. If it is, replace it with a new one.