Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234292 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Radio Broadcast cannot be Received (Bad Reception)  


PROCEDURE

1.CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY
a.

Check the radio automatic station search function by activating it.

OK:

Automatic station search function stops on a station.




OK

NG

2.CHECK OPTIONAL COMPONENTS
2.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

OK:

Optional components are installed.


NOTICE:

Do not remove optional components without permission of the customer.




OK

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

NG

3.CHECK RADIO ANTENNA
3.CHECK RADIO ANTENNA
a.

Remove the pull top antenna pole sub-assembly from the antenna with holder assembly


b.

Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.

OK:

Noise occurs.


Result
Result Proceed to
OK (for Column Shift Type) A
OK (for Floor Shift Type) B
NG C



A

B

C

4.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (ANTENNA)
4.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (ANTENNA)
a.
E276819

Remove the antenna connector from the radio and display receiver assembly.


b.

Turn the ignition switch to ACC with the radio and display receiver assembly connector connected.


c.

Turn on the radio and turn into AM mode.


d.

Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.

OK:

Noise occurs.


Result
Result Proceed to
OK A
NG (for Column Shift Type) B
NG (for Floor Shift Type) C



A

5.CHECK PULL TOP ANTENNA POLE SUB-ASSEMBLY

B

C

5.CHECK PULL TOP ANTENNA POLE SUB-ASSEMBLY
a.

Check that the pull top antenna pole sub-assembly is securely installed (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA POLE>INSTALLATION).

OK:

The pull top antenna pole sub-assembly is installed properly.




OK

6.CHECK FENDER ANTENNA ASSEMBLY

NG

REINSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY

6.CHECK FENDER ANTENNA ASSEMBLY
a.

Replace the fender antenna assembly and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA>REMOVAL).

OK:

Radio broadcasts can be received normally.


Result
Result Proceed to
OK A
NG (for Column Shift Type) B
NG (for Floor Shift Type) C



A

END (FENDER ANTENNA ASSEMBLY IS DEFECTIVE)

B

C