Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234276 RADIO ANTENNA A

AUDIO / VIDEO  RADIO ANTENNA  REMOVAL  


PROCEDURE

Hide 86309B 1.REMOVE PULL TOP ANTENNA POLE SUB-ASSEMBLY

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55301 4.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

Hide 86392 5.REMOVE ANTENNA ORNAMENT

B355092

a.

Remove the antenna ornament as shown in the illustration.


Hide 6.REMOVE SIDE STEP ASSEMBLY RH (w/ Side Step)

Hide 76621D 7.REMOVE FRONT FENDER MUDGUARD RH (w/ Front Fender Mudguard)

Hide 86300 9.REMOVE FENDER ANTENNA ASSEMBLY

a.
B355093

Disconnect each connector.


b.

Remove the bolt and detach the 5 clamps.


c.
B355094

Remove the bolt and fender antenna assembly.