Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234292 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

E280378E03
0.656,1.094 1.198,1.271 0.542,0.177 10 false Volume- 1.51,4.417 1.875,4.865 0.365,0.448 10 false Off Hook 0.75,4.469 1.198,4.719 0.448,0.25 10 false Voice 1.115,6.083 3.156,6.365 2.042,0.281 10 false Steering Pad Switch Assembly 2.344,4.406 2.719,4.813 0.375,0.406 10 false On Hook 1.313,1.083 1.969,1.26 0.656,0.177 10 false Volume+ 5.031,0.427 5.323,0.604 0.292,0.177 10 false AU1 5.052,2.063 5.354,2.24 0.302,0.177 10 false AU2 5.042,1.542 5.344,1.719 0.302,0.177 10 false EAU 5.042,2.688 5.333,2.865 0.292,0.177 10 false AU3 6.375,0.531 6.792,0.75 0.417,0.219 10 false SW1 6.375,1.656 6.76,1.833 0.385,0.177 10 false SWG 6.375,2.135 6.813,2.375 0.438,0.24 10 false SW2 6.375,2.76 6.771,2.958 0.396,0.198 10 false SW3 5.917,3.219 6.375,3.396 0.458,0.177 10 false J139 2.177,1.083 2.563,1.26 0.385,0.177 10 false Down 4.688,0.531 4.875,0.708 0.188,0.177 10 false z3 4.688,1.656 4.875,1.833 0.188,0.177 10 false z3 4.688,2.771 4.875,2.948 0.188,0.177 10 false z3 4.667,0.344 4.844,0.521 0.177,0.177 10 false 10 4.708,1.438 4.802,1.615 0.094,0.177 10 false 7 4.688,2.125 4.875,2.302 0.188,0.177 10 false z3 4.708,1.948 4.802,2.125 0.094,0.177 10 false 9 4.708,2.573 4.802,2.75 0.094,0.177 10 false 8 5.5,0.552 5.792,0.729 0.292,0.177 10 false J45 5.5,1.656 5.792,1.833 0.292,0.177 10 false J45 5.5,2.771 5.844,2.948 0.344,0.177 10 false J45 6.135,0.448 6.313,0.625 0.177,0.177 10 false 21 6.135,1.563 6.313,1.74 0.177,0.177 10 false 23 6.135,2.677 6.313,2.854 0.177,0.177 10 false 24 6.125,2.042 6.302,2.219 0.177,0.177 10 false 22 5.583,1.458 5.677,1.635 0.094,0.177 10 false 3 5.51,2.135 5.802,2.313 0.292,0.177 10 false J45 5.583,1.938 5.677,2.115 0.094,0.177 10 false 5 5.573,0.333 5.667,0.51 0.094,0.177 10 false 6 5.573,2.563 5.667,2.74 0.094,0.177 10 false 4 0.823,2.208 1.115,2.385 0.292,0.177 10 false Left 1.521,2.219 1.906,2.396 0.385,0.177 10 false Right 2.198,2.208 2.563,2.385 0.365,0.177 10 false Back 2.792,2.198 3.177,2.375 0.385,0.177 10 false Enter 4.771,3.25 5.781,3.677 1.01,0.427 10 false Spiral Cable Sub-assembly 5.917,3.396 7.156,3.844 1.24,0.448 10 false Radio and Display Receiver Assembly 2.958,1.083 3.198,1.26 0.24,0.177 10 false Up 0.906,5.365 2.823,5.635 1.917,0.271 10 false Steering Pad Switch RH Side 0.896,3 2.813,3.271 1.917,0.271 10 false Steering Pad Switch LH Side

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH>INSPECTION).



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).


b.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the J139 radio and display receiver assembly connector.


b.

Disconnect the J45 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J139-21 (SW1) - J45-6 (AU1) Always Below 1 Ω
J139-22 (SW2) - J45-5 (AU2) Always Below 1 Ω
J139-24 (SW3) - J45-4 (AU3) Always Below 1 Ω
J139-23 (SWG) - J45-3 (EAU) Always Below 1 Ω
J139-21 (SW1) - Body ground Always 10 kΩ or higher
J139-22 (SW2) - Body ground Always 10 kΩ or higher
J139-24 (SW3) - Body ground Always 10 kΩ or higher
J139-23 (SWG) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR