Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27M0U _51 Engine / Hybrid System _049139 CRUISE CONTROL _0234343 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL SET INDICATOR LIGHT)
a.

Using the Techstream, perform the Active Test (see page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. SET Cruise control SET indicator light ON/OFF -

OK:

Indicator light turns on/off.




OK

2.READ VALUE USING TECHSTREAM (CRUISE CONTROL MAIN SWITCH)

NG

2.READ VALUE USING TECHSTREAM (CRUISE CONTROL MAIN SWITCH)
a.

Using the Techstream, read the Data List (see page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
SET/COAST Switch -SET switch signal / ON or OFF ON: -SET switch on
OFF: -SET switch off
-

OK:

The display is as specified in the normal condition column.



Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 3UR-FE) C
NG (for 3UR-FBE) D


A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

C

D