Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.REMOVE REAR WHEEL LH
2.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
42431
3.REMOVE REAR DISC LH
4.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING LH
46580
5.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
46590
6.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
7.REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
42611E
8.REMOVE REAR AXLE LH HUB BOLT
Using SST and a screwdriver or equivalent to hold the axle hub, remove the hub bolt.
42611E
9.INSTALL REAR AXLE LH HUB BOLT
Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.
Install hub nuts to prevent damage to the hub bolts.
Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.
Remove the washer and hub nut.
Do not damage the threads of the hub bolts.
10.INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
46590
11.INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
46580
12.INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
13.INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING LH
14.CHECK PARKING BRAKE INSTALLATION
42431
15.INSTALL REAR DISC LH
16.ADJUST PARKING BRAKE SHOE CLEARANCE
17.CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
18.INSTALL REAR WHEEL LH
19.CHECK PARKING BRAKE TRAVEL
20.ADJUST PARKING BRAKE TRAVEL