Home › Drivetrain › AXLE › STEERING KNUCKLE
RM27M0U _52 Drivetrain _049151 AXLE _0234391 STEERING KNUCKLE A

AXLE  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 43442B 1.INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD)

a.
F042765

Using a brass bar and hammer, tap in a new retainer cap.

NOTICE:
·

The retainer cap is a non-reusable part.

·

Do not damage the retainer cap.




Hide 43212L 2.INSTALL STEERING KNUCKLE OIL SEAL LH

a.
C179621E03
1.292,0.458 0.833,0.458 false 1.115,0.458 1.115,0.938 true 0.573,0.385 0.896,0.552 0.323,0.167 10 false SST

Using SST and a press, press in a new oil seal.

SST
09950-60020  (09951-01030)
09950-70010  (09951-07100)

NOTICE:
·

The oil seal is a non-reusable part.

·

Do not damage the steering knuckle oil seal.




Hide 43212 3.INSTALL STEERING KNUCKLE LH

a.

Install the front suspension upper arm to the steering knuckle with the nut.

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)


b.

Install a new clip.

HINT:

If the holes for the clip are not aligned, tighten the nut up to another 60.



Hide 48626 4.CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

Hide 45047 5.CONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 43502C 6.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Install the front axle hub (see page Drivetrain>AXLE>FRONT AXLE HUB>INSTALLATION).


Hide 89543 7.CONNECT FRONT SPEED SENSOR LH

a.
C159315

Connect the front speed sensor to the steering knuckle with the bolt.

Torque:
11 N*m (107 kgf*cm, 8 ft.*lbf)


b.

Attach the clip to the steering knuckle.


Hide 8.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Hide 9.CHECK SPEED SENSOR SIGNAL

Hide 10.CHECK SRS WARNING LIGHT

Hide 11.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

a.

Inspect and adjust the front wheel alignment (see page Suspension>SUSPENSION>FRONT WHEEL ALIGNMENT>ADJUSTMENT).