Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.REMOVE REAR WHEEL LH
2.DRAIN BRAKE FLUID
3.DISCONNECT REAR BRAKE FLEXIBLE HOSE
Disconnect the brake tube from the flexible hose with union nut wrench while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the clip.
4.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 bolts and disconnect rear disc brake cylinder.
Do not twist or bend the flexible hose.
Do not disconnect the flexible hose from the disc brake cylinder.
42431
5.REMOVE REAR DISC LH
46550E
6.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING LH
46580
7.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
46590
8.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
9.REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
46430
10.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
89546
11.DISCONNECT REAR SPEED SENSOR LH
42312
12.REMOVE REAR AXLE SHAFT
Remove the 4 nuts and rear axle shaft together with the parking brake plate.
Remove the O-ring.
42312C
13.REMOVE REAR AXLE SHAFT OIL SEAL
Using SST, tap out the oil seal.
Be careful not to damage the axle housing hole.