The skid control ECU is connected to the combination meter via the CAN communication system.
Refer to TRAC OFF indicator light circuit (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TRAC OFF Indicator Light Remains ON).
When replacing the VSC actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Check if a CAN communication system DTC is output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
(See pagePower Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
Check the skid control ECU connector connection condition.
The connector is securely connected.
OK
NG
Disconnect the A17 ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A17-8 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A17-16 (GND1) - Body ground | Always | Below 1 Ω |
OK
NG
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the TRAC OFF indicator light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| TRC(TRAC) OFF Indicator Light | TRAC OFF indicator light*1
TRAC OFF indicator*2 |
ON / OFF | Observe combination meter |
Check that the TRAC OFF indicator light*1 or TRAC OFF display*2 on the combination meter assembly turn on or off in accordance with the Techstream operation.
The TRAC OFF indicator light*1 or TRAC OFF display*2 on the combination meter assembly turns on or off in accordance with the Techstream operation.
When the TRAC OFF indicator light remains illuminated*1 or TRAC OFF displayed*2, there may be an open in the wire harness of the combination meter or abnormalities in the meter circuit.
*1: w/o Multi-information Display
*2: w/ Multi-information Display
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Remove the VSC OFF switch (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VSC OFF SWITCH>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 - 9 | Switch is pressed | Below 1 Ω |
| Switch is not pressed | 10 kΩ or higher |
OK
NG
Disconnect the A17 ECU connector.
Disconnect the J22 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A17-4 (CSW) - J22-9 | Always | Below 1 Ω |
| A17-4 (CSW) - Body ground | Always | 10 kΩ or higher |
| J22-6 - Body ground | Always | Below 1 Ω |
OK
NG