Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234407 YAW RATE AND DECELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE SENSOR

a.

Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.


b.

Install the yaw rate sensor with the 2 nuts (labeled C).

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

Make sure that the sensor is oriented correctly.

·

If the sensor is dropped, replace it.

·

Securely connect the connector.

·

When installing the sensor, make sure to avoid impacts to the sensor.

C353074E01
1.646,0.677 1.802,0.875 0.156,0.198 10 false C 3.49,0.646 3.646,0.844 0.156,0.198 10 false C 5.042,0.5 5.198,0.698 0.156,0.198 10 false A 5.542,1.146 5.698,1.344 0.156,0.198 10 false B 6.667,2.219 7.083,2.417 0.417,0.198 10 false Front 3.427,1.854 4.365,2.052 0.938,0.198 10 false Arrow Stamp




Hide 71100S 2.INSTALL CENTER FRONT SEAT (for Center Seat)

Hide 58910C 3.INSTALL CONSOLE BOX ASSEMBLY (for Separate Seat Type)

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 89183A 5.PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

a.

Perform the yaw rate sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


Hide 89183A 6.CHECK YAW RATE SENSOR SIGNAL