DTC CHECK/CLEAR
Check for DTCs.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes.
Check the details of the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>TRAILER BRAKE CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Following the Techstream display, check the "DTC" and "DTC ODO" data in the Data List (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>TRAILER BRAKE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
Up to 5 "DTC" and "DTC ODO" data are stored.
Clear the DTCs.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Operate the Techstream to clear the codes. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes.
According to the display on the Techstream, select the trouble code data display with the clear button.