Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TRAILER BRAKE CONTROL SYSTEM
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234409 TRAILER BRAKE CONTROL SYSTEM S

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  TRAILER BRAKE CONTROL SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


NOTICE:

Turn the ignition switch off before removing any parts.


HINT:
·

If no abnormality is found when inspecting parts, check the trailer brake control ECU (brake control with bracket relay) and check for poor contact at ground points.

·

If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

·

When 2 or more DTCs are detected, perform each circuit inspection until the problem is identified.

·

All DTCs in the table below are detected in accordance with 1 trip detection logic.



DTC
DTC Code Detection Item See page
C14A0 Slider Switch Circuit (Click here)
C14A1 Gain Rocker Switch (+) Circuit (Click here)
C14A2 Gain Rocker Switch (-) Circuit (Click here)
C14A3 Type Push Button Switch Circuit (Click here)
C14A4 Output Circuit Temperature High / Over Current (Click here)
C14A5 Output Circuit Unintended Current (Click here)
C14A6 Output Circuit Negative Voltage (Click here)
C14A7 ECU Malfunction (Click here)
U0101 Lost Communication with TCM (Click here)
U0129 Lost Communication with Brake System Control Module (Click here)
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module (Click here)