Home › Vehicle Interior › AIR CONDITIONING › CONDENSER
RM27M0U _58 Vehicle Interior _049154 AIR CONDITIONING _0234419 CONDENSER A

AIR CONDITIONING  CONDENSER  REMOVAL  


PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 52119A 4.REMOVE FRONT BUMPER COVER

Hide 32907A 5.DISCONNECT OIL COOLER HOSE (w/ Air Cooled Transmission Oil Cooler)

a.
E188044

Using pliers, grip the claws of the clip and slide the clip.


b.

Disconnect the 2 oil cooler hoses.


Hide 88711 7.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E344964E01
0.104,0.083 0.417,0.281 0.313,0.198 10 false *A 0.094,2.344 0.406,2.542 0.313,0.198 10 false *B

Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.

Text in Illustration
*A w/o Air Cooled Transmission Oil Cooler
*B w/ Air Cooled Transmission Oil Cooler

NOTICE:
·

When removing the bolt, do not allow any tools to contact the pipe.

·

When removing the bolt, hold a part of the pipe near the connector.




b.

Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88710 8.DISCONNECT AIR CONDITIONER TUBE ASSEMBLY

a.
E186078

Remove the 2 bolts and air conditioner tube assembly from the cooler condenser assembly.

NOTICE:
·

When removing the bolt, do not allow any tools to contact the pipe.

·

When removing the bolt, hold a part of the pipe near the connector.




b.

Remove the O-ring from the air conditioner tube assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88460 9.REMOVE COOLER CONDENSER ASSEMBLY

a.

Remove the 2 bolts.


b.
E283113E01
0.05,0 0.261,0.202 0.211,0.202 10 *A 0.05,2.277 0.261,2.479 0.211,0.202 10 *B

Remove the cooler condenser assembly as shown in the illustration.

Text in Illustration
*A w/o Air Cooled Transmission Oil Cooler
*B w/ Air Cooled Transmission Oil Cooler


Hide 88474 10.REMOVE COOLER DRYER

a.
I030086

Using a 14 mm hexagon socket wrench, remove the cap from the modulator.


b.
I032475

Remove the O-ring from the cap.


c.
E050386

Using pliers, remove the cooler dryer.