Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234450 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (driver side junction block assembly) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC Code DTC Detection Condition Trouble Area
C1AB8 The blind spot monitor sensor cannot communicate with the main body ECU (driver side junction block assembly).
·

CAN communication system

·

Main body ECU (driver side junction block assembly)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Check for CAN Communication System DTCs (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

OK:

CAN communication system DTCs are not output.




OK

2.REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)

NG

2.REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
a.

Replace the main body ECU (driver side junction block assembly) with a new or normally functioning one.



NEXT

3.CHECK DTC
3.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH (master) B
DTC is output from the blind spot monitor sensor LH (slave) C



A

END (MAIN BODY ECU [DRIVER SIDE JUNCTION BLOCK ASSEMBLY] IS DEFECTIVE)

B

C