This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.
If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AC1 | When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. | Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
Check the installation condition of the blind spot monitor sensor RH (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).
Take the appropriate action in accordance with the result.
NEXT
Install the rear bumper (See page Vehicle Interior>EXTERIOR>REAR BUMPER(for Resin Type Bumper)>INSTALLATION).
Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).
Blind Spot Monitor Beam Axis Confirmation performs normally.
OK
NG