| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 TRANSMISSION CONTROL ECU BRACKET | 89539N | - | - | - |
| 2 | NO. 1 TRANSMISSION CONTROL ECU BRACKET | 89539M | - | - | - |
| 3 | TCM | 89535B | ( )
|
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | BATTERY CLAMP SUB-ASSEMBLY | 74404A | - | - | - |
| 5 | ECM | 89661 | - | - | - |
| 6 | AIR CLEANER CASE SUB-ASSEMBLY | 17701 | - | - | - |
| 7 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | 17801 | - | - | - |
| 8 | AIR CLEANER CAP WITH AIR CLEANER HOSE | - | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
89539N
1.INSTALL NO. 2 TRANSMISSION CONTROL ECU BRACKET
89539M
2.INSTALL NO. 1 TRANSMISSION CONTROL ECU BRACKET
89535B
3.INSTALL TCM
|
Install in this Direction | - | - |
Install the TCM to the continuously variable transaxle assembly with the 2 bolts.
Connect the TCM connector to rotate the lever and engage the claw.
Rotate the lever until the claw of the TCM connector makes a click sound.
Engage the clamp to connect the engine wire to the No. 2 transmission control ECU bracket.
74404A
4.INSTALL BATTERY CLAMP SUB-ASSEMBLY
89661
5.INSTALL ECM
17701
6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
7.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
8.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
51442C
10.INSTALL ENGINE UNDER COVER LH
51410
11.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
12.PERFORM UPDATE ECU SECURITY KEY
13.PERFORM INITIALIZATION
14. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART