| *A | for Driver Side | *B | for Front Passenger Side |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 12 | HOLE PLUG | - | - | - | - |
| 13 | FRONT DOOR GLASS SUB-ASSEMBLY | 68101 | ( )
|
- | - |
| 14 | FRONT DOOR WINDOW REGULATOR ASSEMBLY | - | - | - | - |
| 15 | POWER WINDOW REGULATOR MOTOR ASSEMBLY | 85710E | ( )
|
- | - |
| *1 | FRONT DOOR WINDOW REGULATOR SUB- ASSEMBLY | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
67655
6.REMOVE FRONT DOOR TRIM GARNISH
67837A
9.REMOVE FRONT DOOR VENT SEAL
67855B
10.REMOVE FRONT DOOR PANEL PROTECTOR
12.REMOVE HOLE PLUG
14.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY
85710E
15.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
| *a | Drum | - | - |
Remove the 3 bolts.
Using a screwdriver with its tip wrapped in protective tape, carefully remove the power window regulator motor assembly while holding down the drum.