| ● | Non-reusable part | - | - |
| *1 | REAR DOOR WINDOW REGULATOR SUB- ASSEMBLY | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67603
4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68196B
6.REMOVE REAR DOOR BELT FRONT SEAL
68198
7.REMOVE REAR DOOR BELT REAR SEAL
68142C
9.REMOVE REAR DOOR GLASS RUN
11.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85710F
12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
| *a | Drum | - | - |
Remove the 3 bolts.
Using a screwdriver with its tip wrapped in protective tape, carefully remove the power window regulator motor assembly while holding down the drum.