The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear axle hub bolt replacement are shown below.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2. DISABLE BRAKE CONTROL
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
46310B
3.REMOVE PARKING BRAKE ACTUATOR ASSEMBLY
4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Remove the 2 bolts and separate the rear disc brake caliper assembly from the rear axle beam assembly.
Use wire or an equivalent tool to keep the rear disc brake caliper assembly from hanging by the rear flexible hose.
42431
5.REMOVE REAR DISC
42312E
6.REMOVE REAR AXLE HUB BOLT
| *a | Service Nut |
| *b | Hold |
| *c | Turn |
Temporarily install 2 service nuts to the rear axle hub bolts as shown in the illustration.
Thread diameter: 12.0 mm (0.472 in.)
Thread pitch: 1.5 mm (0.0591 in.)
Install the service nuts to prevent damage to the rear axle hub bolts.
Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly remove the rear axle hub bolt.
Do not damage the threads of the rear axle hub bolts.
42312E
7.INSTALL REAR AXLE HUB BOLT
Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.
| *a | Service Nut |
| *b | Washer |
| *c | Hold |
| *d | Turn |
Install a washer and service nut to the rear axle hub bolt as shown in the illustration.
Thread diameter: 12.0 mm (0.472 in.)
Thread pitch: 1.5 mm (0.0591 in.)
Recommended washer thickness is 5 mm (0.197 in.) or more.
Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the service nut.
Install the service nuts to prevent damage to the rear axle hub bolts.
Do not damage the threads of the rear axle hub bolts.
Remove the 3 service nuts and washer from the 3 rear axle hub bolts.
42431
8.INSTALL REAR DISC
9.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Install the rear disc brake caliper assembly to the rear axle beam assembly with the 2 bolts.
Do not twist the rear flexible hose when installing the front disc brake caliper assembly.
46310B
10.INSTALL PARKING BRAKE ACTUATOR ASSEMBLY
11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
12. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART