|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 21 | REAR DECK FLOOR BOX | 64993 | - | - | - |
| 22 | DECK BOARD ASSEMBLY | 58410B | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 23 | SERVICE PLUG GRIP | G3834 | - | - | - |
52390B
1.TEMPORARILY TIGHTEN REAR DIFFERENTIAL SUPPORT ASSEMBLY
|
|
2.INSTALL WIRE HARNESS CLAMP BRACKET
G1143
3.INSTALL MOTOR CABLE BRACKET
52380F
4.INSTALL FRONT DIFFERENTIAL SUPPORT ASSEMBLY
30900T
7.INSTALL REAR TRACTION MOTOR BREATHER PLUG
|
|
41653D
8.INSTALL UPPER DIFFERENTIAL MOUNT STOPPER
Support the rear traction motor with transaxle assembly with a transmission jack.
Be careful not to drop the rear traction motor with transaxle assembly.
Install 2 upper differential mount stoppers with 2 new bolts.
Do not tighten the bolts with the inner cylinder or mount cushion tilted.
G1050
9.INSTALL REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY
Install the rear traction motor with transaxle assembly to the rear differential support assembly with 2 new bolts.
Do not tighten the bolts with the inner cylinder or mount cushion tilted.
52390B
10.FULLY TIGHTEN REAR DIFFERENTIAL SUPPORT ASSEMBLY
|
|
82169A
11.CONNECT NO. 6 FLOOR WIRE
41171
12.INSTALL REAR DIFFERENTIAL PROTECTOR
52383C
13.INSTALL DIFFERENTIAL SUPPORT PROTECTOR
42340B
14.CONNECT REAR DRIVE SHAFT ASSEMBLY LH
| *a | Matchmark | - | - |
Align the matchmarks on the rear drive shaft assembly LH and differential side gear shaft sub-assembly.
Install the 4 nuts and 4 washers.
Do not damage the rear drive shaft inboard joint boot.
42330
15.CONNECT REAR DRIVE SHAFT ASSEMBLY RH
64993
21.INSTALL REAR DECK FLOOR BOX
58410B
22.INSTALL DECK BOARD ASSEMBLY
G3834
23.INSTALL SERVICE PLUG GRIP