| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | INSPECT SPIRAL CABLE SUB-ASSEMBLY | - | ( )
|
- | - |
| 2 | STEERING SENSOR | 89245B | ( )
|
- | - |
| 3 | SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY | - | - | - | - |
| *1 | SPIRAL CABLE SUB-ASSEMBLY | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
1.INSPECT SPIRAL CABLE SUB-ASSEMBLY
89245B
2.INSTALL STEERING SENSOR
| *a | Guide | *b | Pin |
| *c | Lock Pin | - | - |
Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.
The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.
Remove the lock pin from the steering sensor.
3.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
45286B
4.INSTALL UPPER STEERING COLUMN COVER
45287
5.INSTALL LOWER STEERING COLUMN COVER
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
10. UPDATE ECU SECURITY KEY
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY
When the steering sensor is replaced with a new one, ECU security key is necessary.
11.INSPECT SRS WARNING LIGHT
45130
12.INSPECT HORN BUTTON ASSEMBLY
13. PERFORM DIAGNOSTIC SYSTEM CHECK
14. PERFORM POWER STEERING ECU INITIAL SETTING
15.CHECK STEERING WHEEL CENTER POINT
16. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART