|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Lithium soap base glycol grease | - | - |
47121
1.INSTALL BRAKE PEDAL PAD
47110
2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Temporarily install the brake pedal support assembly with the 2 bolts and 2 nuts.
Tighten the 2 nuts and 2 bolts in the order shown in the illustration.
Install 2 new clips.
Engage the clamp to install the wire harness to the brake pedal support assembly.
3.CONNECT ENGINE ROOM MAIN WIRE
47264A
4.INSTALL PUSH ROD PIN
|
Lithium soap base glycol grease | - | - |
Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip.
Be sure to install the push rod pin in the correct direction.
47101A
5.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support assembly as shown in the illustration.
84345
6.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
9.INSTALL STEERING COLUMN ASSEMBLY
10.INSPECT AND ADJUST BRAKE PEDAL
11. PERFORM CALIBRATION
12. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
13. CHECK FOR AND CLEAR DTCS