Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for Front Door) › 2020.08–2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0443943 SIDE AIRBAG SENSOR(for Front Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B593000N01
4.5,1 6.833,2.333 2.333,1.333 2.969,3.646 2.969,3.313 false 6.49,0.26 6.823,0.26 false 5.667,2.333 5.667,1 false 2.76,1.385 2.76,1.052 false 6.448,0.604 6.781,0.604 false 5.052,1.792 5.052,1.458 false 6.25,1.833 6.25,1.5 false 5.479,2.958 5.813,2.958 false 4.573,3.479 4.906,3.479 false 5.75,3.51 6.083,3.51 false 6.073,3.875 6.406,3.875 false 3.583,1.833 3.583,1.5 false 6.323,0.115 6.604,0.469 0.281,0.354 18 false 1 6.292,0.448 6.573,0.802 0.281,0.354 18 false 2 4.958,3.344 5.24,3.698 0.281,0.354 18 false 3 5.01,1.813 5.292,2.167 0.281,0.354 18 false 4 5.854,2.823 6.135,3.177 0.281,0.354 18 false 6 6.188,1.854 6.469,2.208 0.281,0.354 18 false 5 6.74,3.75 7.021,4.104 0.281,0.354 18 false 7 6.417,3.385 6.698,3.74 0.281,0.354 18 false 8 2.99,3.656 3.271,4.01 0.281,0.354 18 false 9 2.75,1.385 3.219,1.74 0.469,0.354 18 false 10 3.521,3.625 3.833,3.823 0.313,0.198 10 false x3 3.552,1.833 3.708,2.031 0.156,0.198 10 false ● 4.583,1.083 4.958,1.323 0.375,0.24 12 false *A 5.75,1.094 6.125,1.333 0.375,0.24 12 false *B

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 FRONT DOOR LOWER FRAME BRACKET GARNISH 67491A - - -
4 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL - - - -
5 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL - - - -
6 FRONT DOOR TRIM GARNISH 67655 - - -
7 FRONT DOOR TRIM BOARD SUB-ASSEMBLY 67601 (Click here) - -
8 FRONT DOOR GLASS INNER WEATHERSTRIP 68171B (Click here) - -
9 FRONT DOOR SERVICE HOLE COVER 67831 (Click here) - -
10 SIDE AIRBAG PRESSURE SENSOR 8983A (Click here) - -

*A for Driver Side *B for Front Passenger Side
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side airbag pressure sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Parking support brake system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B473126

Be sure to read Precaution thoroughly before servicing.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 67655 6.REMOVE FRONT DOOR TRIM GARNISH

Hide 67601 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68171B 8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67831 9.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 8983A 10.REMOVE SIDE AIRBAG PRESSURE SENSOR

a.
B596997C01
1.677,0.802 0.677,0.802 true 0.5,0.708 0.813,0.865 0.313,0.156 10 false *a 4.615,0.104 4.896,0.458 0.281,0.354 18 false ii 0.167,0.094 0.448,0.448 0.281,0.354 18 false i 0.354,1.771 0.729,2.01 0.375,0.24 12 false *A 2.729,1.813 3.104,2.052 0.375,0.24 12 false *B
*A w/ Smart Entry and Start System *B w/o Smart Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B593001N01
0.375,0.063 0.885,0.417 0.51,0.354 18 false i, ii 3.865,0.031 4.146,0.385 0.281,0.354 18 false iii

i.

Remove the nut.

NOTICE:

Do not reuse the nut.



ii.

Disengage the claw to pull out the side airbag pressure sensor.

NOTICE:

If the side airbag pressure sensor has been dropped, replace it with a new one.



iii.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR