The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Power seat is available only on the driver side.
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
71910A
3.REMOVE FRONT SEAT HEADREST ASSEMBLY
72123A
4.REMOVE FRONT SEAT TRACK BRACKET OUTER COVER RH
72127A
5.REMOVE FRONT SEAT TRACK BRACKET INNER COVER RH
72137
6.REMOVE SEAT TRACK BRACKET OUTER COVER RH
72157A
7.REMOVE SEAT TRACK BRACKET INNER COVER RH
8.REMOVE FRONT SEAT ASSEMBLY
Using a T50 "TORX" socket wrench, remove the 2 bolts on the rear side of the front seat assembly.
Operate the slide and vertical power seat switch knob to move the front seat assembly to the rearmost position.
Using a T50 "TORX" socket wrench, remove the 2 bolts on the front side of the front seat assembly.
Operate the reclining power seat switch knob to move the seatback to the upright position.
Operate the slide and vertical power seat switch knob to move the front seat assembly to the center position.
Operate the slide and vertical power seat switch knob to move the front seat assembly to the uppermost position.
Disconnect the cable from the negative (-) auxiliary battery terminal.
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Disconnect the 2 connectors and disengage the clamps under the front seat assembly.
Disconnect the front seat airbag assembly connector under the front seat assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Remove the front seat assembly.
2 or more people are required when carrying the front seat assembly out of the vehicle.
Protect the front seat leg.
Be careful not to damage the front seat assembly, body exterior or body interior.