| *1 | CLUTCH PEDAL SUPPORT SUB-ASSEMBLY | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
MP Grease | - | - |
| *1 | CLUTCH PEDAL STOPPER NUT | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
MP Grease | - | - |
31321
1.INSTALL CLUTCH PEDAL PAD
31453B
2.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSHING
|
MP Grease | - | - |
Install a new clutch master cylinder push rod clevis bushing to the clutch pedal sub-assembly.
Install the clutch master cylinder push rod clevis bushing from the left side of the vehicle.
Apply MP grease to the inside of the clutch master cylinder push rod clevis bushing.
31324A
3.INSTALL CLUTCH PEDAL SHAFT COLLAR
31301C
4.INSTALL CLUTCH PEDAL BUSHING
|
MP Grease | - | - |
Apply MP grease to both sides of 2 new clutch pedal bushings.
Install the 2 clutch pedal bushings to the clutch pedal sub-assembly.
31301P
5.INSTALL CLUTCH PEDAL TURNOVER BUSHING
|
MP Grease | - | - |
Apply MP grease to the inside of the clutch pedal turnover bushing.
Install the clutch pedal turnover bushing to the clutch pedal sub-assembly.
31353
6.INSTALL CLUTCH PEDAL SPRING HOLDER
|
MP Grease | - | - |
Apply MP grease to the contact surface of the clutch pedal spring holder.
Install the clutch pedal spring holder to the clutch pedal support sub-assembly.
31301
7.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
|
|
31301A
8.INSTALL CLUTCH PEDAL SPRING
Move the clutch pedal sub-assembly to the full stroke position.
Install the clutch pedal spring to the clutch pedal sub-assembly and clutch pedal support sub-assembly.
9.INSTALL CLUTCH PEDAL SUPPORT ASSEMBLY
31453A
10.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
|
MP Grease | - | - |
Apply MP grease to the clutch master cylinder push rod clevis with hole pin.
Connect the clutch master cylinder assembly to the clutch pedal sub-assembly with the clutch master cylinder push rod clevis with hole pin.
Install the clutch master cylinder push rod clevis with hole pin from the left side of the vehicle.
Install a new clip to the clutch master cylinder push rod clevis with hole pin.
31301F
11.INSTALL CLUTCH PEDAL STOPPER BOLT
| *1 | Clutch Pedal Stopper Bolt | *2 | Clutch Pedal Stopper Nut |
| *3 | Clutch Pedal Support Sub-assembly | - | - |
Temporarily install the clutch pedal stopper bolt and clutch pedal stopper nut to the clutch pedal support sub-assembly.
Without depressing the clutch pedal, check that the clearance shown in the illustration is as specified.
1.8 to 2.8 mm (0.0709 to 0.1102 in.)
Fix the clutch pedal stopper bolt and tighten the clutch pedal stopper nut.
12.INSTALL STEERING COLUMN ASSEMBLY
84520
13.INSTALL CLUTCH START SWITCH ASSEMBLY
89280
14.INSTALL CLUTCH PEDAL STROKE SENSOR ASSEMBLY
15.INSPECT CLUTCH PEDAL