| *A | for HV Model TMC Made | *B | w/ Height Control Sensor |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.SEPARATE REAR SHOCK ABSORBER ASSEMBLY
Remove the 2 bolts and 2 nuts, and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Because the nuts have their own stoppers, do not turn the nuts. Loosen the bolts with the nuts secured.
Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks.
48258C
2.INSTALL REAR LOWER COIL SPRING INSULATOR
Install the rear lower coil spring insulator to the rear axle beam assembly.
Securely insert the protrusion of the rear lower coil spring insulator into the guide holes of the rear axle beam assembly.
48259A
3.INSTALL REAR UPPER COIL SPRING INSULATOR
Install the rear upper coil spring insulator to the rear coil spring.
Install the rear upper coil spring insulator so that the dimension between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.
The identification mark of the rear coil spring should be towards the underside.
48231B
4.INSTALL REAR COIL SPRING
|
Identification Mark | - | - |
Set the rear coil spring to the rear axle beam assembly.
Make sure that there is no gap between the coil end of the rear coil spring and the stopper of the rear lower coil spring insulator.
Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
5.CONNECT REAR SHOCK ABSORBER ASSEMBLY
Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks and temporarily install the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.
Because the nuts have their own stoppers, do not turn the nuts. Tighten the bolts with the nuts secured.
89408C
6.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)
47319F
7.INSTALL REAR FLEXIBLE HOSE LH
47318F
8.INSTALL REAR FLEXIBLE HOSE RH
10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY RH
11.INSTALL NO. 2 PARKING BRAKE WIRE ASSEMBLY
12.INSTALL NO. 1 PARKING BRAKE WIRE ASSEMBLY
13.INSTALL REAR WHEEL
14. STABILIZE SUSPENSION
42110F
15.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY
48540
16.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
|
|
17.INSPECT REAR WHEEL ALIGNMENT
18.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for HV Model TMC Made)
19.CHECK FOR SPEED SENSOR SIGNAL
for HV Model TMC Made:
for HV Model TMMF Made:
for Gasoline Model TMC Made:
for Gasoline Model TMMF Made:
20.PERFORM INITIALIZATION
21. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL (for HV Model TMC Made)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART