| *1 | FRONT FLEXIBLE HOSE | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 13 | REMOVE FRONT DRIVE SHAFT ASSEMBLY | 43420 | ( )
|
- | - |
| 14 | FRONT DRIVE SHAFT HOLE SNAP RING | 43420G | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front drive shaft assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEELS
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
51442C
3.REMOVE ENGINE UNDER COVER LH
51441C
4.REMOVE ENGINE UNDER COVER RH
Perform the same procedure as for the LH side.
5.DRAIN HYBRID TRANSAXLE FLUID
43502H
6.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the front axle shaft nut completely, otherwise the threads of the drive shaft may be damaged.
Using a 30 mm deep socket wrench, remove the front axle shaft nut while applying the brakes.
43215
8.REMOVE STEERING KNUCKLE SEAL
48069
11.SEPARATE FRONT LOWER NO.1 SUSPENSION ARM SUB-ASSEMBLY
43420
12.DISCONNECT FRONT DRIVE SHAFT ASSEMBLY
| *a | Matchmark | - | - |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
Using a plastic hammer, disconnect the front drive shaft assembly from the front axle assembly.
Do not push the front axle assembly towards the outside of the vehicle any further than necessary.
Check that there is no foreign matter on the deflector or contact surfaces.
Do not damage the front axle outboard joint boot.
Do not damage the front disc brake dust cover.
Do not damage the deflector.
If it is difficult to separate the front drive shaft assembly from the front axle assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.
43420
13.REMOVE FRONT DRIVE SHAFT ASSEMBLY
Using SST, remove the front drive shaft assembly.
Do not damage the front drive shaft oil seal.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly.
43420G
14.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the front drive shaft hole snap ring.