| *A | for HV Model TMC Made | - | - |
| *1 | REAR BRAKE DUST COVER | *2 | REAR CALIPER SUPPORT BRACKET |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear axle hub and bearing assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION (for HV Model TMC Made)
3.REMOVE REAR WHEEL
890C0A
4.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.
Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.
Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.
Be careful not to damage the rear axle hub and bearing assembly or connector cover.
42450B
7.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
Remove the 4 bolts, rear axle hub and bearing assembly, rear brake dust cover and rear caliper support bracket from the rear axle beam assembly.
Do not drop the rear brake dust cover and rear caliper support bracket.