Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for Center Pillar) › from 2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0443944 SIDE AIRBAG SENSOR(for Center Pillar) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Center Pillar)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B620280N01
0.167,3.708 3.385,5.542 3.219,1.833 1.844,2.396 3.385,3.542 1.542,1.146 0.438,4.052 2.063,5.385 1.625,1.333 3.583,1.083 3.917,1.083 false 5.677,1.792 6.01,1.792 false 4.802,2.729 5.135,2.729 false 5.26,4.75 5.26,5.083 false 6.542,3.854 6.542,4.188 false 2.5,4.208 2.5,4.542 false 1.292,5 1.625,5 false 4.625,5.104 4.625,5.438 false 6.438,0.26 6.813,0.26 false 6.448,0.667 6.781,0.667 false 2.323,2.813 2.323,3.146 false 1.885,2.438 2.26,2.677 0.375,0.24 12 false *A 0.219,3.75 0.594,3.99 0.375,0.24 12 false *B 0.469,4.094 0.844,4.333 0.375,0.24 12 false *C 1.667,4.833 1.948,5.188 0.281,0.354 18 false 3 2.427,4.573 2.708,4.927 0.281,0.354 18 false 4 2.25,3.167 2.531,3.521 0.281,0.354 18 false 4 3.396,0.917 3.677,1.271 0.281,0.354 18 false 5 6.469,4.208 6.75,4.563 0.281,0.354 18 false 6 4.563,5.448 5.104,5.781 0.542,0.333 18 false 8 5.198,5.094 5.708,5.448 0.51,0.354 18 false 9 5.156,2.552 5.635,2.917 0.479,0.365 18 false 10 6.063,1.625 6.615,2 0.552,0.375 18 false 7 6.26,0.135 6.542,0.49 0.281,0.354 18 false 1 6.271,0.521 6.552,0.875 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 REAR UNDER SIDE COVER 76974F - - -
4 REAR DOOR INSIDE SCUFF PLATE 67918F - - -
5 REAR DOOR OPENING TRIM WEATHERSTRIP 62332A - - -
6 FRONT DOOR SCUFF PLATE 67914B - - -
7 FRONT DOOR OPENING TRIM WEATHERSTRIP 62312B - - -
8 LAP BELT OUTER ANCHOR COVER 73233 - - -
9 FRONT SEAT OUTER BELT ASSEMBLY 73220 - - -
10 CENTER PILLAR LOWER GARNISH 62414A - - -

*A for Gasoline Model *B for HV Model
*C for LH Side - -

B620281N01
2.26,4.021 2.26,4.292 false 3.792,3.615 3.792,3.885 false 2.104,4.313 2.656,4.667 0.552,0.354 18 false 11 3.885,3.906 4.438,4.26 0.552,0.354 18 false 12

Procedure Part Name Code
Z101186

Z101188

Z101187

11 FRONT SEAT OUTER BELT ASSEMBLY 73220 (Click here) - -
12 SIDE NO. 1 AIRBAG SENSOR 89831A (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side No. 1 side airbag sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system*1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the LH and RH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B473126

Be sure to read Precaution thoroughly before servicing.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 76974F 3.REMOVE REAR UNDER SIDE COVER (for HV Model)

Hide 67917F 4.REMOVE REAR DOOR INSIDE SCUFF PLATE

Hide 62331A 5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 67913B 6.REMOVE FRONT DOOR SCUFF PLATE

Hide 62311B 7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 73233 8.REMOVE LAP BELT OUTER ANCHOR COVER

Hide 73210 9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

Hide 62413A 10.REMOVE CENTER PILLAR LOWER GARNISH

Hide 73210 11.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B620238C10
1.313,0.813 0.406,0.813 true 0.198,0.708 0.51,0.865 0.313,0.156 10 false *a 4.583,0.104 4.865,0.458 0.281,0.354 18 false ii 0.229,0.073 0.51,0.427 0.281,0.354 18 false i 3.031,1.792 3.406,2.031 0.375,0.24 12 false *A 1.854,1.802 2.115,2.021 0.26,0.219 12 true *B
*A w/ Entry and Start System *B w/o Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B620282N01
1.271,0.229 1.417,0.531 0.146,0.302 18 true i 5.385,0.052 5.563,0.354 0.177,0.302 18 true ii 5.583,1.448 5.771,1.719 0.188,0.271 18 true ii 4.854,1.198 5.104,1.479 0.25,0.281 18 true iii 5.583,1.115 5.823,1.406 0.24,0.292 18 true iii

i.

Disconnect the pretensioner connector.

HINT:

Refer to How to Connector or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the 2 bolts.


iii.

Disengage the guides to remove the front seat outer belt assembly.



Hide 89831 12.REMOVE SIDE NO. 1 AIRBAG SENSOR

a.
B620238C11
0.396,0.781 1.333,0.781 true 0.333,0.094 0.615,0.448 0.281,0.354 18 false i 4.604,0.094 4.885,0.448 0.281,0.354 18 false ii 0.198,0.677 0.479,1.031 0.281,0.354 10 false *a 1.865,1.792 2.115,2.021 0.25,0.229 12 true *B 3.052,1.781 3.302,2.01 0.25,0.229 12 false *A
*A w/ Entry and Start System *B w/o Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B620283N01
0.427,0.042 0.708,0.396 0.281,0.354 18 false i 3.927,0.042 4.521,0.396 0.594,0.354 18 false ii, iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag sensor connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the bolt.

NOTICE:

Loosen the bolt while holding the side No. 1 airbag sensor because the side No. 1 airbag sensor guide is easily damaged.



iii.

Disengage the claw to remove the side No. 1 airbag sensor.

NOTICE:

If the side No. 1 airbag sensor has been dropped, replace it with a new one.