The main body ECU (multiplex network body ECU) detects the ON/OFF signal of the adaptive high beam switch.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Auto High Beam Main Switch | Auto high beam switch signal | OFF or ON | OFF: Auto high beam switch not pressed
ON: Auto high beam switch pressed |
- |
| Tester Display |
|---|
| Auto High Beam Main Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>AUTOMATIC HIGH BEAM MAIN SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H4 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H47,H4)Location & Routingewd_type=routing;type=c,c;code=H47,H4 Click Connector(H47)Instrument Panel>Instrument Panel Wire / Speaker Wire>Auto High Beam Switchewd_type=component;type=c;code=H47;pinno=5,2 Click Connector(H4)Instrument Panel>Instrument Panel Wire / Speaker Wire>Main Body ECUewd_type=component;type=c;code=H4;pinno=14 |
||
| H47-5 (+B) - H4-14 (AHBI) | Always | Below 1 Ω |
| H47-5 (+B) or H4-14 (AHBI) - Body ground | Always | 10 kΩ or higher |
| H47-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
NG