When the automatic high beam system is on, the main body ECU (multiplex network body ECU) illuminates the auto high beam switch indicator.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*1
*1: w/ Entry and Start System
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Range | Diagnostic Note |
|---|---|---|---|
| Automatic High Beam Switch Light | Auto high beam switch indicator light | OFF or ON | - |
| Tester Display |
|---|
| Automatic High Beam Switch Light |
Auto high beam switch indicator light illuminates.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>AUTOMATIC HIGH BEAM MAIN SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H47)Location & Routingewd_type=routing;type=c;code=H47 Click Connector(H47)Instrument Panel>Instrument Panel Wire / Speaker Wire>Auto High Beam Switchewd_type=component;type=c;code=H47;pinno=3 |
||
| H47-3 (IND+) - Body ground | Ignition switch off*1 Always*2 | 11 to 14 V |
*1:for HV Model
*2:for Gasoline Model
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H4 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H47,H4)Location & Routingewd_type=routing;type=c,c;code=H47,H4 Click Connector(H47)Instrument Panel>Instrument Panel Wire / Speaker Wire>Auto High Beam Switchewd_type=component;type=c;code=H47;pinno=4 Click Connector(H4)Instrument Panel>Instrument Panel Wire / Speaker Wire>Main Body ECUewd_type=component;type=c;code=H4;pinno=15 |
||
| H47-4 (AZBI) - H4-15 (AHID) | Always | Below 1 Ω |
| H47-4 (AZBI) or H4-15 (AHID) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
NG