|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
42110F
1.TEMPORARILY TIGHTEN REAR AXLE BEAM ASSEMBLY
|
|
Slowly jack up the rear axle beam assembly with an engine lifter using 2 wooden blocks and 2 attachments or equivalent tools, and temporarily install the rear axle beam assembly to the body with the 2 bolts.
2.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER
Temporarily install the rear axle beam assembly to the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.
Because the nuts have their own stoppers, do not turn the nuts. Tighten the bolts with the nuts secured.
48258C
3.INSTALL REAR LOWER COIL SPRING INSULATOR LH
48258B
4.INSTALL REAR LOWER COIL SPRING INSULATOR RH
42450B
5.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
42450A
6.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY RH
7.INSTALL REAR WHEEL
42110F
9.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY
10.FULLY TIGHTEN REAR SHOCK ABSORBER
Fully tighten the rear shock absorber (lower side) with the 2 bolts while keeping the 2 nuts from rotating.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
11.INSPECT REAR WHEEL ALIGNMENT