1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
30300
2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
31210
3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)
31250
4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)
32101B
5.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)
Hold the crankshaft with SST.
Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.
13405
6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)
Hold the crankshaft with SST.
Remove the 6 bolts and flywheel.
11401L
7.REMOVE REAR ENGINE OIL SEAL
Using a knife, cut off the lip of the oil seal.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.