15100C
1.INSTALL OIL PUMP SEAL
Apply MP grease to the lip of a new oil pump seal.
Keep the lip free of foreign matter.
Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover edge.
Do not tap the oil seal at an angle.
Wipe off extra grease from the crankshaft.
0 to 1.0 mm (0 to -0.04 in.)
13407
2.INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY
12305
3.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
16361A
4.INSTALL FAN AND GENERATOR V BELT
16361A
5.ADJUST FAN AND GENERATOR V BELT
16361A
6.INSPECT FAN AND GENERATOR V BELT
7.INSPECT FOR ENGINE OIL LEAK
51441C
8.INSTALL ENGINE UNDER COVER RH (for Plastic Type)
51405A
9.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)
10.INSTALL FRONT WHEEL RH